Research project Osires: filters for injection moulding with recyclates

Recyclates bring foreign particles into the injection moulding machine. A filter insert holds them back from the melt, clogs while doing so and has to be changed.

In the simulation of plastic melts, fine elements such as filters can now be modelled together with solids. In the joint research project Osires, SK Industriemodell, Odenwälder Filtersysteme, IANUS Simulation and the Kunststoff-Zentrum SKZ are developing a simulation tool for melt and solids to optimise such filters digitally. It is to provide a basis for deciding on filter size and change intervals.

I work for the project as a subcontractor and simulate what happens inside the filter insert itself.

Simulation on two scales

The slots of a filter insert are orders of magnitude smaller than the machine it sits in. A model of the whole machine cannot resolve each particle at each slot, so the simulation runs on two scales: I compute the microscale, IANUS Simulation the macroscale.

In GeoDict, the software for digital material R&D by Math2Market, I compute the flow through a digital model of a filter insert by Odenwälder Filtersysteme. The flow carries particles to the slots, where some are held back. With every step more particles sit in the insert, the flow is computed again, and its resistance rises.

On the macroscale, where melt and solids are computed for the whole machine, the filter insert would be a black box without the microscale. The microscale simulation says which particles it holds back and how it clogs.

Both models describe the same insert, one particle by particle, the other as a component in the machine. Which quantities pass between them, and how to check that nothing is lost on the way, is a separate part of my work in the project.

Partners and funding

The partners of the joint project are SK Industriemodell GmbH, Odenwälder Filtersysteme GmbH, IANUS Simulation GmbH and Kunststoff-Zentrum SKZ. cvt engineering is a subcontractor. The full German title is “Osires – Optimierung der Kreislaufwirtschaft durch simulationsgestützte Filterlösungen für Rezyklate im Spritzguss” (optimising the circular economy with simulation-based filter solutions for recyclates in injection moulding). The project is funded by the German Federal Ministry of Research, Technology and Space (BMFTR) in the programme KMU-innovativ from 1 January 2026 to 31 December 2027.

Reports

Simulation of filter clogging

I simulate clogging by particles for other filters and fluids as well, on a model built from design data or on a µCT scan, so that variants of a filter can be compared before a trial. The post on dust inside a nonwoven filter and on its surface shows such a simulation for an air filter medium.